1、平時養護

地下電纜探測儀設備應保留于枯燥常溫的環境中，并定時充電，通常三個月充一次，充電時刻8-12小時。

設備應防止長時刻在陽光下暴曬，防止長時刻在低溫（-10℃以下）下運用。否則會損壞液晶，促進機殼老化。

盡量防止雨天運用，假如不能防止請做好防雨防潮預備，一旦儀器淋雨受潮應在zui短時刻內除水排潮，否則會形成儀器的損壞。

在運用過程中假如發現儀器異常請及時與廠家聯絡，防止影響運用耽擱工作。

2、準確充電

充電器接入AC 220 V 50HZ市電，充電器指示燈亮（綠色），然后將充電頭刺進地下電纜綜合探測儀主機充電座（被充電主機在關機狀況），此刻充電器指示燈變紅，標明體系充電正常，過一段時刻后充電指示燈由紅變綠，此刻并不標明電池已充溢電量，僅僅闡明充電器由大電流快充狀況轉為小電流慢充狀況，只要確保充電時刻到達8-12小時即可。

假如充電頭刺進主機充電座后（被充電主機在關機狀況），充電器指示燈不變紅，而開機又無顯現，闡明機內電池松動或接觸不良，此刻打開電池蓋板將電池裝好即可。

3、地下電纜探測儀儀器自檢

1、面板按鍵查看

1．發射機：按3.1.2功用簡介操作各鍵是不是正常。

2. 接納機：按3.2.2功用簡介操作各鍵是不是正常。

2、工作狀況查看

1.信號輸出與接納互檢

直連線五芯航空頭刺進發射機五芯航空座，將線分隔順直并短接兩夾子，按下發射機電源開關，阻抗顯現00001Ω。圖標轉動。

手持接納機坐落直連線鄰近，按下接納機電源開關，幾秒鐘后接納機安穩工作接納到直連線上的信號并有顯現，移動接納機信號顯現會有改變。闡明發射機、接納機工作正常。

發射機在感應狀況下，翻開發射機，將接納機的接納頻率調至和發射機一致的頻率，看接納機能否接納到信號，移動接納機，看接納機的數據有無改變;

2.耦合鉗的查看

把耦合鉗與發射機相連，按下發射機電源開關，阻抗顯現10Ω左右，一起聽到耦合鉗宣布動靜（低頻）。闡明耦合鉗工作正常。

3.“A”字架的查看

直連線與地下電纜探測儀發射機相連，紅黑兩線反向順直并一起接地，按下發射機電源開關。翻開“A”字架并與接納機相連，按下接納機電源開關，到紅夾或黑夾接地址鄰近，扎地上有信號，提起無信號。闡明“A”字架工作正常。